OCL Series
Inverter Output Power Reactor
- Typeinfo : Input&Cutout Reactor
- Order hotline: +86-577 62870600
- Brief Introduction
- Technical Paramete
- Product Size
General
This product is made of high-quality imported silicon steel sheet and high-quality copper wire through advanced technology. Small size, low temperature rise, and no noise. It is usually installed at the output end of the inverter's DC speed regulator to limit the capacitive charging current of the inverter and the motor. The capacitive charging current of the connecting cable passivates the voltage rise rate of the PWM wave output by the inverter. It is one of the important components between the inverter and the motor to improve the power factor, improve the quality of the power grid, and smooth the waveform.
Main Technical data
Voltage drop：1%-2%
Rated operating voltage：380V/50Hz
Electric strength: iron core-winding 3000VAC/50Hz/10mA/60s no arcing no breakdown;
Insulation resistance: iron core-winding 1000VDC, Insulation resistance ≥100MV
Noise of reactor: less than 35dB (measured from 1 meter away in horizon from reactor)
Temperature rise less than 60K
Note: The above mentioned data is the reference of typical models, we can design and produce according to the special requirement by user, would reserve the right to change the technical data.
Get a quote
Prev：ACL Series
Next：DCL Series
Message
Cell Phones
E-mail